It is very exciting getting into the art of woodworking. However, with it being such a large field, many people can feel a little uneasy trying to start out. Don’t let this happen to you. Instead, embrace the following tips, and get started today putting your skills to work with some wood.
Tape can be your friend when gluing stained wood together. Place the two pieces of wood together in a clamp and tape the seam before applying the glue. Carefully cut the tape along the joint and then separate the two pieces of the wood and apply the glue along the joint. Clamp together and allow to dry. The tape will keep the glue off the wood and is easy to remove once the glue is dried.
Woodworking can be expensive. The actual wood is one of the most expensive parts of any project. The rest of the cost is usually labor, glue and hardware. Sometimes you can save some money by buying a cheaper grade of wood for areas of your project that are not visible. Areas like drawers, backs and bottoms are excellent places to use this wood.
Keep the floors safe in your woodworking shop. Dust builds up on the floor, making it dangerous for walking. Coat the slippery areas of your shop with a mixture of crushed walnut shells and paint. The walnut shells are just the right consistency to keep the floor rough enough for walking, even when sawdust builds up.
When learning a new woodworking technique, practice it over and over again. Repetition is the best way to learn these skills. So find some cheap wood (scrap wood works), and go at it for some time to hone your skills. This will make it so you’re less likely to make mistakes during important projects.
A handy tool for every woodworking shop is a stair gauge. They are typically used for laying out stair jacks, but they can also be used as a clamp for a carpenter’s square. This will transform your carpenter’s square from a straight-line tool, into a straight guide for your saw. The square will get you wonderfully straight cuts all the time.
A small metal ruler is handy to carry around in your pocket for quick measuring. It has a tendency to fall out of your pockets, though. If it falls out, try buying a metal one and use a magnet for picking up screws to keep it from falling out. This magnet helps you keep the objects together and in your pocket.
Learn about using pilot holes. This is pretty simple to do. When driving a screw or hammering a nail into a little piece of wood or getting pretty close to the edge of a piece, it tends to split. Sometimes it’s unavoidable to put a fixing into a place like this. However, drilling a hole through the joint that’s a bit smaller than the fixing can prevent it from splitting.
Woodworking is a craft enjoyed by young and old alike and has been treasured for centuries. In order to get the most out of it, you must be working towards honing your skills. So, use the tips that have been discussed to help you get going in the right direction today.…